Explanation
During system initialization or in response to
a command, multiple console support (MCS) cannot activate a console
because MCS cannot determine the device type or the definition is
not correct. The system will make the indicated changes to the console.
In
the message text:
- consname
- The console name.
- text
- one of the following:.
- RC: rc - 3279-2 IS ASSUMED
- RC: rc - 3277-2 IS ASSUMED
- where rc is one of the following:
- 01 - An I/O error on read partition query.
- 02 - An I/O error on read modified while the system was trying
to obtain the response to the read partition query.
- 03 - The result of the read partition query contained a bad attention
identifier (AID).
- 04 - The system could not find the usable-area structure field
in response to the read partition query.
- RNUM(xx) APPLIED
- where xx is the default roll number applied
by the system.
- SEG(yy) APPLIED
- where yy is the default SEG value applied by
the system.
- AREA(mm,nn,...)
- where mm,nn... are the default out-of-line
area sizes applied by the system.
System action
The system applies the default indicated in the
message.
Operator response
If the applied default RNUM, SEG, or AREA
value is not acceptable, enter a CONTROL S or CONTROL A command to
change them.
System programmer response
Check the specification for RNUM,
SEG or AREA in the CONSOLxx parmlib member for
incorrect values.
Source
Communications task (COMMTASK)
Module
IEECVFTV, IEECVSLG, IEECVSLR
Routing code
Descriptor code