IEE925I

Explanation
A CONTROL command specified a parameter that applies
only to consoles. The command must be entered from a full capability
console. 
In the message text: cm
The command, or a portion of the command, entered.
op
The parameter specified on the command.
NON
Applies to devices such as a printer.
COMMAND ISSUED IS command
command is the text of the command that was
originally entered.

System action
The system rejects the command.

Operator response
Correct the command.  Enter the command again,
if desired. Enter DISPLAY C,K for a list of CONTROL command functions.
 The
only way to direct a CONTROL command from one CRT device to another
is to use the L=name parameter on the CONTROL command.

Source
Master scheduler

Module
IEE6703D

Routing code
*

Descriptor code
5