IEE748E

Explanation
SLIP processing attempted to issue a message, but
could not issue it.

System action
The system: Ends SLIP processing
Holds all messages issued by SLIP processing until SLIP message
processing is restarted
Writes an SVC dump
Writes a logrec data set error record

Operator response
To correct the problem, enter any valid SLIP
SET or SLIP MOD command. You can also use a SLIP MOD command that
enables or disables a non-existent trap to restart SLIP message processing.
If it cannot be restarted, notify the system programmer.

System programmer response
Search problem reporting data bases
for a fix for the problem. If no fix exists, report the problem to
the IBM® Support Center. Provide the SVC dump and
the logrec data set error record.

Source
Recovery termination manager (RTM)

Module
IEECB906

Routing code
10

Descriptor code
3