Explanation
A SLIP MOD command requested that the system enable
a non-ignore program event recording (PER) trap. However, another
non-ignore PER SLIP trap is already enabled. The system enables only
one non-ignore PER trap at any particular time.
In the message
text:
- ID-xxxx
- The SLIP trap identifier specified on the SLIP command.
- ID-yyyy
- The SLIP trap identifier of the trap currently enabled.
System action
The system ignores the SLIP MOD command.
Operator response
Notify the system programmer. Enter the SLIP
commands specified by the system programmer.
System programmer response
If SLIP trap ID=
xxxx should
be enabled, ask the operator to enter two SLIP MOD commands, as follows:
- One command to disable trap ID=yyyy
- A second command to enable trap ID=xxxx
Source
Module
Routing code
Descriptor code