IEE313I

Explanation
While processing a command, the system detected
one of the following errors: The unit, console identifier, or console name specified on the
command indicates a device type that cannot be used for the purpose
intended by the command. Among the reasons for this are: The device has not been defined or has not been properly defined
in the CONSOLxx member.
The device has been properly defined in the CONSOLxx member, but
the system is unable to accept the device definition. This can be
caused by defining devices that exceed the limit of 99 console definitions
per sysplex.

The command issuer is not authorized.
The command requested that the system vary the hard-copy log offline,
but the system has no current recording log.

If the unit is an output only device, it will be referenced
as O-dev (for example, VARY O-dev,ONLINE).
In the message text: HARDCOPY
A VARY HARDCPY,OFFLINE command was entered.
s
The subchannel set ID.
dddd
The number for the device specified on the command.

System action
The system rejects the command.
If VARY
CN(xx),AUTH=value or VARY CN(nnnnnnnn),AUTH=value was
entered, and the console identifier or name is incorrect or the issuer
is not authorized, the system does not change the authority value
for the specified console.
If a VARY CONSOLE command was entered
for a console name that is a SMCS console or a subsystem console,
the system issues this message to show the status.
If a VARY
CONSOLE command was entered for device number dev or
console name nnnnnnnn and the device is not active
and not ready, the system issues this message to show the status.
If
the unit is offline when an UNLOAD command is entered, then the system
does not process the UNLOAD command. For example, if the UNLOAD 13D
command is entered, when 13D is offline, the system issues message
IEE313I as follows:
IEE313I 13D UNIT REF. INVALID
If
a VARY device command (for example, VARY dev1-dev2,OFFLINE)
is entered and each of the specified units is individually incorrect,
the system displays dev1-dev2 in
the message text.

Operator response
Do the following: For case 1, enter the command again, specifying the correct unit
name.
For case 2, enter the command from a console with master authority.
For case 3, none.

Also, check the SYSLOG of the system where the console
should have been defined for the presence of message IEA195I; this
indicates that one or more console definitions were not accepted.
Issue the "D C,L" command and see whether the console mentioned in
message IEE313I is listed as a validly-defined console.

Source
Consoles or MVS™ Device Allocation

Module
IEECB836, IEECB838, IEECB844, IEECB845, IEECB847,
IEECB849, IEECB850, IEECB852, IEECB854, IEECB855, IEECB856, IEECB858, IEE5703D,
IEE7203D, IEE8603D, IEECB903, IEEMB813, IEEVMNT2, IEFHBONL 

Routing code
*

Descriptor code
5