Explanation
A command is incorrect for one of the following
reasons:
- The command is misspelled or punctuated incorrectly.
- A command valid only at initial program load (IPL) was used after
IPL.
- A command was issued without a prerequisite command.
- The command had an incorrect operand, as in HOLD or RELEASE commands
without a TP operand.
In the message text:
- MODE
- Indicates that ECC was requested in record mode while HIR was
in quiet mode.
- CSCB USE
- Indicates that the maximum number of Telecommunications Access
Method (TCAM) commands had been enqueued when another TCAM command
was submitted.
- cm
- The command that is incorrect.
- blanks
- The operand of the central command was too long, or a framing
quote was not found within 62 bytes.
System action
The system rejects the command.
Operator response
If blanks or cm appears,
enter the command again correctly. For MODE, if desired, enter
the command to place HIR into record mode before resubmitting the
command to place ECC into record mode.
When CSCB USE appears,
resubmit the command at a later time. If the condition persists,
increase the number of command input buffers (CIB) specified on the
INTRO macro in the TCAM main control program (MCP).
Source
Module
IEEMB815, IEE0403D, IEE0603D, IEE0803D, IEE3503D, IEE5503D,
IEE7103D, IEE7503D, IEECB808, IEECB923, IEECB925
Routing code
Descriptor code