IEC915I

Explanation
An error occurred during the processing of a DFP
program that could not be attributed to incorrect user input.
In
the message text: rc
Associates this message with system completion code 219 and with
the return code.
jjj
Job name.
sss
Step name.
ddname
DDname.

The explanation for the hex return code is as
follows: Return Code
Explanation
01
A dump was taken to the SYS1.DUMP data set.
02
A partial dump was taken to the SYS1.DUMP data set.
03
No dump was taken to the SYS1.DUMP data set.

System action
The system issues an SVC Dump, writes a software
error record to the logrec data set, and the task is ended.

Operator response
Start a generalized trace facility (GTF) trace,
and re-create the problem.  Reply to message AHL100A with: TRACE=SYS,USR,SLIP

On
the DD statement for the data set in error, specify: DCB=DIAGNS=TRACE

System programmer response
If the error recurs and the program
is not in error, look at the messages in the job log for more information.
Search problem reporting data bases for a fix for the problem. If
no fix exists, contact the IBM® Support
Center. Provide the JCL, the program listing for the job, and the
logrec data set error record.

Programmer response
Make sure that your program does not alter
the DCB or IOB during processing of SVC 25.

Source
DFSMSdfp

Module
IGCT002E

Routing code
11

Descriptor code
6