IEC172I

Explanation
text is one of the following: FCB imageid VERIFY
FORMS OVERLAY
RETHREAD

During SETPRT processing, the operator received and replied
CANCEL to one of these messages for 3800 printer dev: Message IEC128D, requesting that the operator verify the alignment
of forms to the forms control buffer image; imageid is the one to
four-character identifier specified for the image on the FCB operand
of the SETPRT macro instruction.
Message IEC163A, asking that the operator load a forms overlay
frame.
Message IEC164A, asking that the operator change the paper threading.

In the message text: dev
The device number of the specified device.

System action
SETPRT processing ends and places a return code
in register 15.

Operator response
If you decide that you should not have replied
CANCEL to message IEC128D, IEC163A, or IEC164A, rerun the job that
issued the SETPRT macro instruction.  If you tried to perform the
action requested by message IEC128D, IEC163A, or IEC164A but you could
not, or if you think that the message was issued because of a programming
error, notify the programmer whose job issued the SETPRT macro instruction.

Programmer response
If the operator tried to perform the action
requested by message IEC128D, IEC163A, or IEC164A, but could not,
determine why the operator could not perform the action and correct
the problem. If it appears that the system should not have issued
message IEC128D, IEC163A, or IEC164A, there is probably an error in
the values specified for the 3800 printer parameters in the JCL or
on the SETPRT macro instruction.

Source
DFSMSdfp

Module
IGG08113