Explanation
The error occurred during the processing of an
OPEN macro instruction for a graphic data control block.
In
the message text:
- rc
- Associates this message with system completion code E13 and the
return code.
- jjj
- The job name.
- sss
- The step name.
- ddname[-#]
- ddname (followed by a concatenation number if it is part of a
concatenation and not the first DD statement in the concatenation).
- dev
- The device number.
- mod
- The name of the module in which the error occurred.
The explanation for the hex return code is as
follows:
- Return Code
- Explanation
- 04
- The GNCP byte in the DCB contained a value outside the acceptable
range of 1 to 99. The GNCP byte count determines the maximum number
of I/O macro instructions that may be issued before a WAIT macro instruction
is issued.
System action
The task is ended unless the error is to be ignored
as specified in the DCB ABEND exit routine.
System programmer response
If the error recurs and the program
is not in error, look at the messages in the job log for more information.
Search problem reporting data bases for a fix for the problem. If
no fix exists, contact the IBM® Support
Center. Provide all printed output and output data sets related to
the problem and the source program listing for the job.
Programmer response
Probable user error. Correct the errors
causing the abnormal end as indicated by the return code in the message
text. Rerun the job.
Source
Module
Routing code
Descriptor code