Explanation
The error occurred during processing of a QISAM
or BISAM OPEN macro instruction or a BDAM OPEN macro instruction.
In
the message text:
- rc
- Associates this message with system completion code 03D and with
the return code.
- jjj
- The job name.
- sss
- The step name.
- ddname[-#]
- DDname (followed by a concatenation number if it is part of a
concatenation and not the first DD statement in the concatenation).
- dev
- The device number.
- ser
- The volume serial number.
- mod
- The name of the module in which the error occurred.
- dsname
- The data set name.
The explanation for the hex return code is as
follows:
- Return Code
- Explanation
- 04
- An OPEN macro instruction was issued for an indexed sequential
or direct data set. The volume serial numbers on the DD statement
were not specified in the same order that the data set was created.
Change the JCL, specifying the volume serial numbers in the correct
order.
- 08
- An OPEN macro instruction was issued for an indexed sequential
data set. The first volume of the data set does not have a format2
DSCB.
- 0C
- An OPEN macro instruction was issued for a direct data set. The
data set has an indexed sequential organization.
System action
The task is ended unless the error is to be ignored
as specified in the DCB ABEND exit routine.
Operator response
Start a generalized trace facility (GTF) trace,
and re-create the problem. Reply to message AHL100A with:
TRACE=SYS,USR,SLIP
On
the DD statement for the data set in error, specify:
DCB=DIAGNS=TRACE
System programmer response
If the error recurs and the program
is not in error, look at the messages in the job log for more information.
Search problem reporting data bases for a fix for the problem. If
no fix exists, contact the IBM® Support
Center. Provide the SYSOUT output for the job.
Programmer response
Probable user error. Correct the errors
causing abnormal end as indicated by the return code in the message
text. Rerun the job.
Source
Module
Routing code
Descriptor code