IEC129D

Explanation
The current job step did not specify FCB parameters
and the image currently loaded on the printer ddd cannot
be assumed as a default for one of the following reasons: The image is incorrect because of a previous error condition.
The image is not a default image.

In the message text: dev
The device number of the specified UCS printer.

Operator response
For the first occurrence of this message,
load the FCB buffer by entering REPLY xx,‘text,’ where
text is the image-id to be used. STD1 or STD2 may be specified to
load the IBM® forms-control buffer
images. In addition to the image-id, VERIFY or ALIGN can be specified
after a comma.
Specifying VERIFY or ALIGN allows the operator
to align forms to the new image.
The VERIFY option also provides
a printout of the image loaded.
To ignore the request and use
the image currently loaded, enter REPLY xx,‘U’.
If
no image is available for the job step, enter REPLY xx,‘CANCEL’
or REPLY xx,‘C’. The system will end the job if the request
occurred during processing of an OPEN macro instruction. If the request
was due to processing of a SETPRT macro, a return code of (X'04' will
be placed in register 15, and control returned to the program issuing
the SETPRT macro.

Source
DFSMSdfp

Module
IGG0191T, IGG0191V, IGG0197U

Routing code
7

Descriptor code
2