The character set image, specified by the character set code, to be used on the printer could not be found in the image library or image table.
To correct an erroneous specification, mount the requested chain, train or band and enter REPLY xx,‘text’ where text is the correct character set code.
If an alternate character set can be used, select the alternate chain, train or band and enter REPLY xx,‘text’ where text is the alternate character set code followed, if applicable, by FOLD or F and/or VERIFY or V. (If FOLD or F is omitted but VERIFY or V is specified, indicate the omission of FOLD or F by specifying two consecutive commas -- for example, REPLY xx,‘AN,,V’.)
To ignore the request and use the character set image currently in use, enter REPLY xx,‘U’. A reply of ‘U’ for printers other than 4245 is incorrect at the first occurrence.
If no alternate character set can be used, enter REPLY xx,‘CANCEL’ or REPLY xx,‘C’ to cancel the UCS load. The system will end the job if the request occurred during processing of an OPEN macro instruction. If the request was due to processing of a SETPRT macro, a return code of X'04' will be placed in register 15, and control returned to the program issuing the SETPRT macro.
If the error recurs and the program is not in error, look at the messages in the job log for more information. Search problem reporting data bases for a fix for the problem. If no fix exists, contact the IBM® Support Center. Provide the JCL and the program listing for the job.
DFSMSdfp
IGG0191U
7
2