Explanation
The error occurred when an output operation to
a direct access device was requested.
In the message text:
- rc
- Associates this message with system completion code D37 and with
the return code.
- jjj
- The job name.
- sss
- The step name.
- ddname[-#]
- DDname (followed by a concatenation number if it is part of a
concatenation and not the first DD statement in the concatenation).
- dev
- The device number.
- ser
- The volume serial number.
- diagcode
- The DADSM Extend diagnostic code, if available.
- mod
- The name of the module in which the error occurred.
- dsname(member)
- The data set name. Member name if specified.
The explanation for the hex return code is as
follows:
- Return Code
- Explanation
- 04
- A data set opened for output used all the primary space, and no
secondary space was requested. Change the JCL specifying a larger
primary quantity or add a secondary quantity to the space parameter
on the DD statement.
System action
The task is ended unless the error is to be ignored
as specified in the DCB ABEND exit routine. If the error is to be
ignored, the system will attempt to close the DCB before returning
to the user.
Operator response
Start a generalized trace facility (GTF) trace,
and re-create the problem. Reply to message AHL100A with:
TRACE=SYS,USR,SLIP
On
the DD statement for the data set in error, specify:
DCB=DIAGNS=TRACE
System programmer response
If the error recurs and the program
is not in error, look at the messages in the job log for more information.
Search problem reporting data bases for a fix for the problem. If
no fix exists, contact the IBM® Support
Center. Provide the SYSOUT output for the job.
Programmer response
Probable user error. Correct the errors
that caused the abnormal end as indicated by the return code in the
message text. Rerun the job.
Source
Module
Routing code
Descriptor code