Explanation
The error occurred at an end-of-volume.
In
the message text:
- rc
- Associates this message with system completion code 437 and with
the return code.
- jjj
- Job name.
- sss
- Step name.
- ddname[-#]
- DDname (followed by a concatenation number if it is part of a
concatenation and not the first DD statement in the concatenation).
- dev
- Device number.
- ser
- Volume serial number.
- mod
- The name of the module in which the error occurred.
- dsname(member)
- Data set name. Member name if specified.
The values of the hex return codes and their
meanings are as follows:
- Return Code
- Explanation
- 08
- When FEOV was issued, it was found that the DCB pointer was incorrect.
Correct any errors that may have caused the DCB to be incorrect.
- 0C
- DEB not in DEB table.
System action
The task is ended unless the error is to be ignored
as specified in the DCB ABEND exit routine. If the error is to be
ignored, the system will attempt to close the DCB before returning
to the user.
Operator response
Start a generalized trace facility (GTF) trace,
and re-create the problem. Reply to message AHL100A with:
TRACE=SYS,USR,SLIP
On
the DD statement for the data set in error, specify:
DCB=DIAGNS=TRACE
System programmer response
If the error recurs and the program
is not in error, look at the messages in the job log for more information.
Search problem reporting data bases for a fix for the problem. If
no fix exists, contact the IBM® Support
Center. Provide the SYSOUT output for the job.
Programmer response
Probable user error. Correct the errors
causing the abnormal end as indicated by the return code in the message
text. Then rerun the job.
Source
Module
Routing code
Descriptor code