Explanation
In response to a DISPLAY IPLINFO,ZAAPZIIP,STATE
command, this message displays the state of the zAAP on zIIP function.
In
the message text:
- state
- One of the following:
- ACTIVE: zAAP on zIIP is active
- INACTIVE - ZAAPZIIP SYSTEM PARAMETER IS 'NO': The zAAP on zIIP
function is not active because system parameter ZAAPZIIP=NO was specified.
- INACTIVE - NO ZIIP(S) DEFINED TO THIS LPAR: The zAAP on zIIP function
is not active because
- there are no zIIP(s) defined to this LPAR and
- the dynamic CPU addition function is not enabled so no zIIP(s)
can be added to this LPAR after IPL.
- INACTIVE - ZAAP(S) DEFINED TO THIS LPAR: The zAAP on zIIP function
is not active because one or more zAAPs is defined to this LPAR. The
zAAP(s) might be online or offline or in the reserved state.
- INACTIVE - ZAAP(S) INSTALLED ON THE MACHINE: The zAAP on zIIP
function is not active because one or more zAAPs in the configured
state is installed on the machine (not necessarily defined to this
LPAR). The presence of installed zAAPs in the standby or reserved
state does not affect the state of the zAAP on zIIP function.
- INACTIVE - TOO MANY ZAAPS+ZIIPS INSTALLED ON THE MACHINE: The
zAAP on zIIP function is not active because the machine has one or
more zAAPs and the number of zAAPs plus the number of zIIPs exceeds
the number of standard CPs.
The standard CPs, zAAPs, and zIIPs used
in this calculation are those installed on the machine that are in
the configured state (and not necessarily defined to this LPAR). The
presence of installed processors (whether standard CPs, zAAPs, or
zIIPs) in the standby or reserved state does not affect the state
of the zAAP on zIIP function.
- INACTIVE - GLOBAL MACHINE DATA IS NOT AVAILABLE TO THIS LPAR:
The zAAP on zIIP function is not active because this LPAR is not allowed
to find out about the presence of zAAPs on the entire machine. This
security protocol is controlled by the Global Performance Data Control
setting, described in System z10 Processor Resource/Systems
Manager Planning Guide SB10-7153.
System action
The system continues processing.
Source
Module
Routing code
Descriptor code