Explanation
For general information about message IEC161I,
see the explanation for return code 001.
Specific information
for this return code: Open failed for the data set
dsname.
- ccc = 799: Open failed for the data set dsname.
The file was already open on a system that supports secondary lock
structures.
- ccc = 800: Open failed for the data set dsname.
The file is being opened on a system that supports secondary lock
structures. The lock structure associated with the data set is being
quiesced or has completed quiesce.
- ccc = 801: Open failed for the data set dsname.
The file is being opened on a system that supports secondary lock
structures. The lock structure associated with the data set could
not be connected.
System action
The system does not complete the open.
Operator response
System programmer response
- ccc = 799: Verify that the data set is not open in the sysplex.
If the data set is not open, run the job again. The IDCAMS subcommand
SHCDS LISTDS can be used to determine if the data set was opened on
a system that supports secondary lock structures. See access method
services for ICF catalog for the syntax of the command.
- ccc = 800: Submit the jobs if the lock structure has been enabled.
- ccc = 801: Verify the following:
- The data set is using the correct storage class.
- The storage class has a lock set specified.
- The lock set is specified in the DFSMS base configuration definition.
- The DFSMS configuration was validated and activated.
- Verify that the lock structure is defined to the CFRM policy.
- Search the syslog for messages with the IXL or IXC prefixes that
are related to the related lock structure.
Programmer response
- ccc = 799: Contact the system programmer to verify that the data
set is not open in the sysplex.
- ccc = 800: Contact the system programmer to have the lock structure
associated with this data set placed in enable status.
- ccc = 801: Contact the system programmer to verify that the data
set is not open in the sysplex.
Source
Module
Routing code
Descriptor code