Explanation
Where
text is:
{x-name volser size(blks) %full status|
x-name: volser size(blks) %full status}
This
message contains the status of all data sets being used to record
SMF data. It is displayed during IPL, if requested in the SMFPRMxx
parmlib member or in response to a SET SMF or a DISPLAY SMF command.
Note: - This message is issued instead of IEE949I only when an installation
defines a data set name that does not use the SYS1.MANn naming
convention.
- The system does not issue this message when there are no SMF data
sets available. The system issues message IEE366I.
- The message text will split into two lines when the length of
SMF data set name is greater than 18.
The header line contains the following information:
- hh.mm.ss
- The time, given as the hours (00-23), the minutes (00-59), and
the seconds (00-59). The value is 00.00.00 if the TOD clock is not
working when the information is gathered for the display.
- [id]
- An identifier used with the CONTROL C,D command to cancel status
displays written on typewriter or printer consoles or displayed in-line
(not in a display area) on display (CRT) consoles. This identification
number does not appear when the display is presented in a display
area on a display console.
The message text contains the following information
for each SMF data set:
- x
- Either a P or S to indicate whether the data set is a primary
SMF data set or a secondary SMF data set.
- name
- The name of the SMF recording data set.
- volser
- The volume serial number of the volume containing the SMF data
set.
- size(blks)
- The size of the data set, in the number of control intervals.
The control interval length is determined by the installation.
- %full
- The percentage of the data set that is full.
- status
- The data set status as follows:
- ACTIVE
- The data set is now being used to record SMF data.
- ALTERNATE
- The data set is available for use to record SMF data.
- DUMP REQUIRED
- The data set must be dumped before it can be used to record additional
SMF data.
- CLOSE PENDING
- The data set has been switched from SMF and is waiting to be closed
by SMF before it can be dumped.
- *** ERROR ***
- The status of the data set could not be determined or is not valid.
System action
SMF processing continues.
Operator response
If the data set status is *** ERROR ***, notify
the system programmer. Otherwise, no action is needed.
System programmer response
Obtain a console dump of the SMF address
space. Search problem reporting data bases for a fix for the problem.
If no fix exists, contact the IBM® Support
Center.
Note: When a data set name is up to 18 characters long,
the message text is on one line. When the data set name is greater
than 18 characters in length, the message text is split into two lines.
Source
System Management Facilities (SMF)
Module
Routing code
Descriptor code