Explanation
Where
text is:
[NO RESPONSE RECEIVED FROM THE
FOLLOWING SYSTEM(S):
sysxx sysyy syszz … ]
[THE FOLLOWING SYSTEMS WERE SPECIFIED
BUT WERE NOT ACTIVE ------
sysxx sysyy syszz … ]
SYSNAME RESPONSES ------------------------------
sys01 response01
sys02 response02
…
sysnn responsenn
This
message presents aggregated (collected) command responses that result
from issuing the ROUTE command with *ALL or systemgroupname specified.
Note: If
at least one of the command responses is a multi-line message, the
output is formatted as follows:
(first frame)
sys01 RESPONSES --------------------
response01
(next frame)
sys02 RESPONSES --------------------
response02
...
(last frame)
sysnn RESPONSES --------------------
responsenn
In the message
text:
- text
- As many characters of the routed command as will fit on the line.
For ROUTE *ALL, this is 16 characters. For ROUTE systemgroupname,
this is from 12 to 19 characters.
- sys01, sys02,...sysnn
- The names of each of the systems in the sysplex.
- response01, response02,....responsenn
- The responses from each of the systems in the sysplex.
Each
response can be one or more lines.
Note: The responses are sometimes
too long to fit on one line. When a response is more than 71 characters
long, it is split into two lines.
- sysxx, sysyy, syszz,...
- The names of the systems in the sysplex that have not returned
responses within the timeout value in effect for the ROUTE command.
Note: The
IBM-defined default timeout value is 30 seconds.
System action
The system continues processing.
Source
Communications task (COMMTASK)
Module
Routing code
Descriptor code