Explanation
A SLIP trap requested a storage refresh, but the
system has not completed the refresh.
- xxxx
- The SLIP trap identifier specified on the SLIP command.
- keyword
- The specified timing of the data refresh: REFBEFOR for before
or REFAFTER for after.
- number
- The number of the triplet that failed.
- text
- The reason that the triplet failed. One of the following.
- {FIRST | SECOND} OPERAND ADDRESS SPACE WAS NOT ACTIVE.
- The address space specified by the first or second operand was
not active.
- {FIRST | SECOND} OPERAND COULD NOT BE ACCESSED.
- The address space specified by the first or second operand could
not be accessed.
- FIRST OPERAND WAS WRITE PROTECTED.
- The address space specified by the first operand was write protected.
System action
The system does not perform the failing triplet
and subsequent triplets in the SLIP command. If an operand crosses
a page boundary, the system might have performed part of the triplet.
Operator response
Contact the system programmer.
System programmer response
Correct the SLIP command and issue
the command again.
Source
Module
Routing code
Descriptor code