IEE397I

Explanation
form 1 is: SMF DATA SET IS TOO SMALL AND WILL NOT BE USED, DSN=dsname

form
2 is: SMF DATA SET IS TOO SMALL AND WILL NOT BE USED, DSN=
   dsname

The dsname recording
data set is too small to hold the largest possible SMF record (32
kilobytes) and the control information that is required to segment
the record.
Note: This message is issued instead of IEE960I only
when an installation defines a data set name that does not use the
SYS1.MANn naming convention.
In the message
text: dsname
The name of the SMF recording data set.

System action
SMF initialization or SET SMF command processing
continues but ignores the dsname data set. If at
least one valid SMF recording data set is available, SMF continues
recording and issues message IEE388I. Otherwise, SMF will begin to
buffer SMF data into storage until another data set becomes available.

Operator response
Notify the system programmer.

System programmer response
Recreate the dsname data
set using the access method services DEFINE utility and specifying
a larger size. Use the access method services LISTCAT utility to check
the size of all SMF recording data sets. A data set is large enough
if the LISTCAT output shows a HI-ALLOC-RBA value of at least 36863
for the data set. Recreate any data set that is too small.
Note: This
message can be issued when the system tries to use an SMF data set
that was created with extents. SMF data sets cannot have extents.

Source
System Management Facilities (SMF)

Module
IEEMB822

Routing code
2,10

Descriptor code
5