Explanation
System management facilities (SMF) will write records
on the SMF data set, dsname.
SMF issues this
message:
- During SMF initialization to indicate which data set was chosen
by the SMF writer as the current recording data set.
- When a switch in active data sets takes place during system processing.
Note: This message is issued instead of IEE360I only when
an installation defines a data set name that does not use the SYS1.MANn naming
convention.
In the message text:
- ser
- The volume serial number of the volume containing the SMF data
set.
- dsname
- The name of the SMF recording data set.
- hh.mm.ss
- The time, given as the hour (00-23), the minute (00-59), and the
second (00-59).
System action
SMF initially places records in a buffer. When
the buffer is full, SMF writes the data in the buffer to the indicated
data set. If the system fails before the buffer is full, the records
are lost.
Source
System Management Facilities (SMF)
Module
Routing code
Route code for switch SMF processing. *,2
Descriptor code