IEC212I

Explanation
The error occurred during processing of a CLOSE
macro instruction for a data set on a direct access device or tape.
In
the message text: rc
Associates this message with system completion code 414 and with
the return code.
jjj
The job name.
sss
The step name.
ddname[-#]
DDname (followed by a concatenation number if it is part of a
concatenation and not the first DD statement in the concatenation).
dev
The device number.
ser
The volume serial number.
mod
The name of the module in which the error occurred.
dsname
The data set name.

The explanation for the hex return code is as
follows: Return Code
Explanation
04
An I/O error occurred writing a DSCB during processing of a CLOSE
macro instruction.
08
For a QSAM data set either an I/O error occurred while flushing
the buffers during close processing or a close was issued in the caller's
SYNAD routine.

System action
The task is ended unless the error is to be ignored
as specified in the DCB ABEND exit routine.

Operator response
Start a generalized trace facility (GTF) trace,
and re-create the problem.  Reply to message AHL100A with: TRACE=SYS,USR,SLIP

On
the DD statement for the data set in error, specify: DCB=DIAGNS=TRACE

System programmer response
If the error recurs and the program
is not in error, look at the messages in the job log for more information.
Search problem reporting data bases for a fix for the problem. If
no fix exists, contact the IBM® Support
Center. Provide the SYSOUT output for the job.

Programmer response
If an I/O error has occurred, a defective
volume or device may be the cause.  Save the output from the failing
job to aid in the analysis of the problem.
Rerun the job specifying
a different volume or device.  If a scratch volume was being used
when the I/O error occurred, request a different volume.  If that
does not solve the problem request a different device in the UNIT
parameter of the DD statement.  If a specific volume is needed, try
requesting a different device in the UNIT parameter of the DD statement.
Rerun the job.

Source
DFSMSdfp

Module
IFG0201R

Routing code
11

Descriptor code
6