FUTURE QUICK AND WARM STARTS OF THIS IPL WILL FAIL. RE-IPL
OR REPLY ‘GO’ TO CONTINUE COLD START
Explanation
On a system initialization with the CLPA option,
the system needed to write quick/warm start data to the first records
of the PLPA page data set. However, the write failed. None of the
information is accessible to a future initialization.
The
problem was caused by one of the following:- Slot availability problem: There were no available slots on the
PLPA data set
- Storage availability problem: There was no storage available in
order to perform the I/O operation
- I/O error: An I/O error occurred while the system was writing
to the PLPA data set
System action
The system waits for the operator to reply.
Operator response
Notify the system programmer. Enter REPLY
id,GO to continue with the cold start, or reIPL at the system programmer's
request.
System programmer response
Do one of the following, depending
on the problem experienced:
- Slot availability problem: Verify that the PLPA data set is large
enough to hold the quick start records.
- Storage availability problem: Look for other messages and abends
indicating a storage shortage.
- I/O error: Examine the system log for any messages that may indicate
a problem performing I/O to the PLPA data set. Verify that the volume
containing the PLPA data set is defined and configured correctly.
When using this PLPA page data set again, ask the operator
to perform an IPL with the CLPA option.
Source
Auxiliary storage manager (ASM)
Module
Routing code
Descriptor code