IEA912I
RECOVERY/TERMINATION DUMP FAILED [DUE TO cde]

Explanation

During recovery from an error, the system requested an ABEND dump. The dump failed for one of the following reasons:
  • An unopened data control block (DCB) was referenced during validity checking.
  • A task control block (TCB) address that is not valid was referenced during validity checking.
  • A page that was not valid was referenced during validity checking.
  • Storage was unavailable.
  • The DCB type was not correct.
In the message text:
DUE TO cde
SYSMDUMP processing ended abnormally with a completion code of cde.

System action

Except for the case where tasks are prematurely marked dispatchable, the system does not write out the dump.

System programmer response

Correct the original failure and, if the message includes cde, the dump failure. See the system programmer response for completion code cde. In the case where the tasks were prematurely made dispatchable, and enqueue lockout situation was detected and allowed to clear up. However, the information in the dump must be carefully validated because task processing might have changed vital information in common and shared storage areas.

Source

Recovery termination manager (RTM)

Module

IEAVTABD

Routing code

11

Descriptor code

-

Parent topic: IEA messages