ERROR READING VOLUME LABEL.
Explanation
For processing of a VATLST
xx parmlib
member, the system could not read the volume label on a device. The
device address is specified in subsequent messages. One of the following
occurred:
- If message IEA306I precedes this message, an I/O error occurred
when reading the label.
- The volume does not contain a standard label.
- In the case of Mass Storage System (MSS) volume, the volume serial
number on the label does not match the volume serial number requested
from the 3850 MSS. This case can occur when an MSS volume label has
been clipped to a different serial number.
System action
For an MSS volume, the VATDEF entry is ignored;
processing continues with the remaining VATLSTxx entries.
For
non-MSS volumes the system waits for the operator to mount the correct
volume, if all device addresses specified in reply to IEA851A have
not yet had volumes mounted on them. If they have, the system does
not wait; a mount request for the desired volume must be issued later.
Operator response
For MSS volumes, no response is necessary.
For
non-MSS volumes:
- If the wrong volume is mounted, remove it and mount the correct
volume.
- If no volume can be mounted (for example, there is an error on
that device), and the device is listed in IEA860A, reply ’NO’
to message IEA893A when all other required devices have been mounted
(that is, when the required devices are not listed on IEA893A).
Source
Module
Routing code
Descriptor code