Explanation
When the operator caused a restart interruption,
the specified job was in progress. The message asks the operator
to resume the job that was in progress or end it.
In the message
text:
- jobname
- The name of the job that the system was currently processing.
- stepname
- The name of the step that the system was currently processing
or blanks.
- UNKNOWN JOBNAME
- The system could not identify the current job.
- ASID=aaaa
- The address space identifier (ASID)
- MODE=mmmm
- The system was processing one of the following units of work:
- TASK
- A task
- SRB
- A service request
- WAIT
- The system wait task
- *
- A unit of work other than those listed above
- PSW=psw
- The 16-byte program status word (PSW) at the time
of the restart interruption.
System action
The system prompts the operator for a reply.
Operator response
Reply one of the following:
- RESUME
- The job that was in progress continues at the next sequential
instruction.
- ABEND
- The system ends the job with abend X'071'.
When this message is issued, IT
IS EXTREMELY IMPORTANT to respond promptly. This message is issued
as a synchronous WTOR, which will prevent the system from updating
its status on the sysplex couple data set. This, in turn, could lead
to Sysplex Failure Management (SFM) deciding that the system is not
responding normally, and removing it from the sysplex.
Source
Module
Routing code
Descriptor code