Explanation
Because of an error, the communications task (COMMTASK)
failed.
In the message text:
- xxxx
- The reason code, which is one of the following:
- 8001
- The system could not establish a recovery routine.
- 8002
- The system could not attach a needed routine.
- 8004
- The error occurred during a POST.
- 8005
- The error occurred during an update to the command address space
table.
- 8007
- The error occurred during a POST.
- 8008
- An error during system console output processing
- 8009
- An error during system console output processing.
- 800C
- A failure in the timer task.
- Fccc
- An error occurred; the system issued abend code ccc.
System action
The system prompts the operator for a reply.
Operator response
Do one of the following:
- To continue processing with MCS, reIPL the system with MCS.
- To request that processing continue without MCS, reply with any
character. Note that in this case, all 3270 consoles is non-functional,
but programs that are processing that do not need to interact with
a console operator are able to continue.
When this message is issued, IT IS EXTREMELY
IMPORTANT to respond promptly. This message is issued as a synchronous
WTOR, which will prevent the system from updating its status on the
sysplex couple data set. This, in turn, could lead to Sysplex Failure
Management (SFM) deciding that the system is not responding normally,
and removing it from the sysplex.
System programmer response
If Fccc appears,
see the system programmer response for the abend code ccc.
Source
Communications task (COMMTASK)
Module
Routing code
Descriptor code