Explanation
Too many data set names were specified for inclusion
in the LNKLST concatenation.
In the message text:
- xx
- The identifier for the LNKLST or PROG parmlib member that defined
the LNKLST concatenation.
- dsname
- The name of the last data set in the parmlib member
System action
The system did one of the following:
- Accumulated data set names for the LNKLST until its work area
filled up.
- Concatenated as many of the specified data sets to SYS1.LINKLIB
as can be described in the data extent block (DEB) for the LNKLST.
The work area or the DEB were filled up in processing data set dsname.
The system ignores the data set names after dsname.
Operator response
Notify the system programmer. Obtain a stand-alone
dump.
System programmer response
Do one of the following:
- Reduce the total number of extents in the data sets in the parmlib
member.
- Reduce the number of data sets specified for inclusion in the
LNKLST.
To reopen the LNKLST concatenation, have the operator reIPL
the system.
Do not try to reduce the number of extents by compression
while the data sets are opened as part of LNKLST. Data sets must not
be compressed while they are in the LNKLST concatenation.
If
the problem recurs, search problem reporting data bases for a fix
for the problem. If no fix exists, contact the IBM® Support Center. Provide the stand-alone dump.
Source
Contents supervision (CSV)
Module
Routing code
Descriptor code