Explanation
An error was detected in the PARM parameter for
CHECK(RTM,RTM_IEAVTRML).
Message IEAVTRH07I is also issued to
provide information about the valid parameters for this check.
System action
Operator response
System programmer response
Use the MODIFY
hzsproc command
to correct the error.
F
hzsproc,UPDATE,CHECK(IBMRTM,RTM_IEAVTRML),
PARM('NEW(
value)')
The NEW
parameter causes RTM_IEAVTRML to suppress an exception condition
until a new error is found.
F
hzsproc,UPDATE,CHECK(IBMRTM,RTM_IEAVTRML),PARM('ALL')
The
ALL parameter will report an exception condition if any error is detected
by RTM_IEAVTRML.
Problem determination
Look for additional messages in the message
buffer.
Source
Recovery Termination Manager (RTM)
Module
Routing code
Descriptor code
Automation