Explanation
During nucleus initialization, one of the following
contained an incorrect parameter:
- The operator response to message IEA101A
- The system parameters defined in an active IEASYSxx parmlib
member
System action
The system accepts all parameters specified before
the parameter in error. The system prompts the operator to respecify
the incorrect parameter or cancel the use of the parameter for this
IPL.
This message is preceded by explanatory messages IEA301I
and IEA324I.
Operator response
Do one of the following:
- Enter a reply specifying only the corrected parameter and subsequent
parameters.
- Cancel further input by pressing ENTER. In this case, the parameters
accepted by the system remain in effect.
You can specify a parameter again during this response.
System programmer response
If the parameters were correct or
if the problem persists, and a search of the problem reporting data
bases shows no fix, contact the IBM® Support
Center.
Source
System initialization (IPL/NIP)
Module