Explanation
The limit that an installation placed on the amount
of storage available for SVC dump to hold captured dumps is reached.
In
the message text:
- xxxxxxxx
- The amount of storage, in megabytes, specified on the MAXSPACE
parameter of the CHNGDUMP operator command at the time the limit was
reached.
System action
SVC dump ends the capture of the current dump.
This dump is written out to a dump data set, but it is a partial
dump. SVC dump will not allow other dumps to be captured until the
amount of available space is greater than the threshold value. The
threshold value is the lower of two values: 35 megabytes or ten percent
of the MAXSPACE value. To view the amount of available space, use
the DISPLAY DUMP command.
Operator response
Do one of the following:
- If any dump is captured, but there are no available dump data
sets, use the DUMPDS command or another utility to make dump data
sets available.
- If any dump is captured but not required by the installation,
reply D to message IEA793A to delete the dumps.
- Use the MAXSPACE parameter on the CHNGDUMP command to increase
the value of MAXSPACE, allowing SVC dump processing to use more virtual
storage to hold captured dumps.
Source
Routing code
Descriptor code