CNZZ022I Operation cannot be performed. No Message Flood SQA area.

Explanation
 The requested operation requires manipulating
information held in the Message Flood Automation shared common storage
area (SQA), but no SQA area could be located by Message Flood Automation
command processing. This might indicate that: (1) The IEAVMXIT (CNZZVMXT)
message exit was not loaded or activated. (2) The name/token anchor
of the shared common storage area (SQA) could not be located. (3)
The shared common storage area was explicitly freed using a SETMF
FREE command.

System action
 The requested operation is terminated.

Operator response
 To recover from this situation, issue the
K M,UEXIT=Y command to re-instate the IEAVMXIT (CNZZVMXT) exit. If
this message reoccurs after issuing the K M,UEXIT=Y command, report
the problem to the system programmer. To reconnect
message flood automation command processing to this storage, you must
also reload the CNZZCMXT command exit using a SET MPF= command.

System programmer response
 If issuing the K M,UEXIT=Y command
does not resolve the problem, it is likely that the IEAVMXIT (CNZZVMXT)
message exit was not installed or was installed incorrectly. The operating
system attempts to load IEAVMXIT early in IPL processing, so examine
SYSLOG for messages indicating that IEAVMXIT was not successfully
loaded.

Module
 CNZZCMXT

Source
 Consoles (SC1CK)

Routing Code
 * 

Descriptor Code
 5