CNZ4400D SPECIFY CON=XX OR CON=NONE OR RE-IPL

Explanation
The CON keyword needs to be respecified using only the syntax described in the message: CON=xx
CON=NONE

The previous CON request specified in either IEASYSxx or in response to the IEA101A SYSTEM
PARAMETERS message was syntactically correct, however, the CONSOLxx member was found to be unusable.
See messages IEA193I, IEA195I, or IEA301I for more details. IEA187I will be issued (along with
another CNZ4400D reprompt) if the response to CNZ4400D was syntactically incorrect. Please note that
the NOJES3, SHARED, DISTRIBUTED and L keywords are not valid with this response. They already have
been determined and cannot be altered except with a re-IPL.

System action
The system waits for a response from the operator. The system will perform the following actions
depending on the reply: The two alphanumeric or national characters (xx) are appended to CONSOL to form the name of the
CONSOLxx member in Parmlib.
If CON=NONE is specified, the system is initialized with the IBM® defaults for the values of CONSOLxx.

Operator response
Respond to the CNZ4400D message with the correct syntax. If the syntax is not correct, or there
is some problem with the Parmlib member, either IEA187I, IEA193I, IEA195I or IEA301I will be issued
followed by another CNZ4400D prompt. If you need to change the NOJES3, SHARED, DISTRIBUTED or L
keywords, you will need to re-IPL your system.

System programmer response
None.

Module
IEAVNPA1

Source
Consoles (SC1CK)

Routing Code
2,10

Descriptor Code
12