CNZ4301I CONSOLE console-name WAS NOT REMOVED. text
Explanation
The console definition for the console named in the message could not be removed.
In the message text:
- console-name
- The name of the console whose definition was not removed.
- CONSOLE IS ACTIVE
- An active console cannot be removed. Deactivate the console prior to removing it.
- CONSOLE IS NOT DEFINED
- The console named in the message is not defined.
- CONSOLE IS NOT
AN
MCS/SMCS/HMCS/SUBSYSTEM CONSOLE - Only console definitions for MCS/SMCS/HMCS/SUBSYSTEM consoles
can be removed.
- FAILURE OCCURRED DURING PROCESSING
- An error occurred before the console named in the message could be removed. An ABEND will be issued to generate an SVC dump. In most cases, message CNZ0001I will be issued to provide further diagnostics.
- CALLER IS NOT IN SUPERVISOR STATE
- Only callers running in supervisor state can remove console definitions.
- CALLER IS NOT IN KEY ZERO
- Only callers running in key zero can remove console definitions.
- CALLER IS IN CROSS MEMORY MODE
- Only callers not running in cross memory mode can remove console definitions.
- CALLER IS HOLDING LOCKS
- Only callers not holding locks can remove console definitions.
- CALLER IS NOT IN TASK MODE
- Only callers running in task mode can remove console definitions.
System action
The system does not remove the console definition for the console named in the message.
Operator response
Notify the system programmer.
System programmer response
See the explanation in the corresponding insert.
Module
IEAVG730, CNZM1MRB
Source
Consoles (SC1CK)
Routing Code
Hardcopy only or sent to the issuer of the SETCON command.
Descriptor Code
5