CNZ2603I timehmsp AUTOR POLICY {NO POLICY ACTIVE } {POLICY ACTIVATED AT hh.mm.ss ON mm/dd/yyyy NOTIFYMSGS(HC | CONSOLE)} {FROM PARMLIB MEMBERS xx[,xx]… } {--MSG ID-- DELAY MEM RATE ----REPLY TEXT---- } {msgid delay{M|S} ss rate replytxt } [ replytxtcont ]
Explanation
This message is in response to the DISPLAY AUTOR,POLICY command.
In the message text:
- timehmsp
- The time this response to the DISPLAY AUTOR,POLICY command was issued (in hh.mm.ss format).
- HC
- Auto-reply notification messages are sent to the hardcopy log.
- CONSOLE
- Auto-reply notification messages are sent to consoles receiving routing codes 2 and 10. The messages also appear in the hardcopy log.
- msgid
- The message ID of a WTOR.
- delay
- The amount of time, in minutes (M) or seconds (S), to wait, after the WTOR is issued and before auto-reply processing replies to the WTOR.
- ss
- The suffix of the AUTORxx parmlib member that defined this policy entry.
- rate
- The rate limit that will be used by auto-reply processing, when DELAY is set to zero. If DELAY is greater than zero, '---' will be displayed to represent that a rate limit value is not valid.
- replytxt
- The reply that is used if auto-reply processing replies to the WTOR.
- replytxtcont
- The continuation of the reply text.
- hh.mm.ss
- The time when this auto-reply policy was activated.
- mm/dd/yyyy
- The date on which this auto-reply policy was activated.
- xx
- The AUTORxx parmlib member suffixes that specified the policy. This data might wrap to the next line if more than 16 members are used.
System action
None.
Operator response
None.
System programmer response
None.
Module
CNZK1DAR
Source
Consoles (SC1CK)
Routing Code
*
Descriptor Code
5, 8, 9