CEA0602I THE Z/OS DIAGNOSTIC SNAPSHOT OPTION FAILED. SNAPSHOT TYPE: stype DIAG1 = xxxxxxxx DIAG2 = yyyyyyyy DIAG3 = zzzzzzzz SOURCE NAME: Name of SNAPSHOT source TARGET NAME: Data set name of SNAPSHOT target DIAGNOSTIC MESSAGES: Message returned from service
Explanation
The system was unable to complete the z/OS® Diagnostic Snapshot. Make sure that the SNAPSHOT function is configured according to the documentation.
In the message text:
- stype
- Possible snapshot types:
- LOG SUMMARY REPORT
- LOG DETAIL REPORT
- DIAG1 = xxxxxxxx
- Return code from service
- DIAG2 = yyyyyyyy
- DIAG2 specifies the service used, which includes:
- ALLOC DD
- BPXWDYN
- CEACHECK PARM
- EREP
- DIAG3 = zzzzzzzz
- REXX return code
- SOURCE NAME
- Name of the SNAPSHOT source, operlog, or logstream..
- TARGET NAME
- Data set name of the SNAPSHOT target, for internal IBM® use.
- DIAGNOSTIC MESSAGES
- Message returned from service
System action
The indicated z/OS Diagnostic SNAPSHOT data is not available to the CIM provider for the IBMzOS_Incident class.
Operator response
The Diagnostic Messages describe the problem encountered while taking the snapshot. Look up the related service documentation for the diag1 code. If message CEA0602I is accompanied by message IFC119I that indicates the TABSIZE allocation is too small, try lowering the value of LOGRECSUMMARY in the CEAPRMxx parmlib member.
Consider the following specific instances
of the diagnostic values for the CEA0602I message:
- DIAG 1 = -2323, DIAG2 = EREP, DIAG3 = 12
- Data does not exist for the reported time interval. If this was an ABEND dump, follow the general instructions for the operator response when the data set specified in the Diagnostic Messages is empty. For console and SLIP dumps, this message is informational, and data is not posted in the log for these types of dumps.
- DIAG1 = -3833, DIAG2 = EREP
- EREP failed to create the diagnostic SnapShot. Environmental Record Editing and Printing (EREP) creates this diagnostic snapshot, and EREP does not have the resources to create the LOGREC summary report. Internal table (IFCLMAT) has overflowed. Check the EREP message in the data set that appears in the Diagnostic Messages section of the message. For the programmer response, see EREP Reference, or call IBM Level 2 Service.
- DIAG1 = 8, DIAG2 = CEACDMPP, DIAG3 = 391
- The JES subsystem is unavailable. See your system programmer in order to restore the JES subsystem.
Module
CEAPSNPX.
Routing Code
2, 10