CBR7541I DB2 SQL -205, -206: Column missing from OAM table. For new releases refer to migration guide otherwise refer to any new PTFs applied, new column added to tables.

Explanation
 OAM encountered an error when running a bind job
or during OAM execution. 
 This SQL code is one
of a few common SQL errors that have been experienced by OAM users.
The verbiage in the System Programmer Response section below is to
provide the System Programmer more OAM specific guidance than would
be found looking up the SQL code in the DB2® information
center at http://publib.boulder.ibm.com/infocenter/imzic.

System action
 The operation in progress fails.

System programmer response
 These errors indicate that a migration
job (not a bind job) that was supposed to add a column to a table
did not run. The -205 or -206 SQL error indicates that there is missing
column. See High-Level Installation
and Migration Checklists in z/OS DFSMS OAM Planning, Installation, and Storage Administration Guide for Object Support for
a list of OAM the jobs. Note that certain jobs are z/OS® installation specific. Again, note that
this error is related to a migration job rather than a bind job.
 Messages
DSNT408I and DSNX200I with information about the missing column may
accompany this one. The following sample messages accompany a case
in which the EPI column that was to have been added with the SAMPLIB
job CBRSMB2 is missing: DSNT408I SQLCODE = -206, ERROR: EPI IS NOT A COLUMN OF AN INSERTED
TABLE, UPDATED TABLE, OR ANY TABLE IDENTIFIED IN A FROM CLAUSE
DSNX200I -DBD1 BIND SQL ERROR USING DB2ADM AUTHORITY PLAN=CBROAM
DBRM=CBRKCMT STATEMENT=257 SQLCODE=-206 SQLSTATE=42703 TOKENS=EPI
CSECT NAME=DSNXORSO RDS CODE=-100

 For information on SQL error reason codes, visit the DB2 information center at http://publib.boulder.ibm.com/infocenter/imzic. 

Source
 Object Access Method (OAM)

Routing Code
 2

Descriptor Code
 4