CNZ1100I hh.mm.ss MONITOR DISPLAYSPACE={ON|OFF} DSNAME={ON|OFF} TIMESTAMP={ON|OFF}MSGTYPE SETCON MN NUMBER OF RECEIVERSJOBNAMES enst connum CONSOLES [tsonum TSO USERS]SESS enst connum CONSOLES [tsonum TSO USERS]STATUS enst connum CONSOLES [tsonum TSO USERS]
Explanation
This message is issued in response to a DISPLAY OPDATA,MONITOR command.
Note that if there are currently TSO users receiving any of the JOBNAMES, SESS or STATUS message types, the number of TSO users receiving each message type is included in the display.
In the message text:
- hh.mm.ss
- Time that the message was issued.
- SPACE={ON|OFF}
-
- ON
- Demount messages will also display the available space on the direct access volume.
- OFF
- Demount messages will not display the available space on the direct access volume.
- DSNAME={ON|OFF}
-
- ON
- Mount messages will also display the name of the first non-temporary data set allocated on the volume to which the messages refer. No data set name appears in messages for data sets with a disposition of DELETE.
- OFF
- Mount messages will not display the name of the first non-temporary data set allocated on the volume to which the messages refer.
- TIMESTAMP={ON|OFF}
-
- ON
- The timestamp is included in the monitor messages that can contain a timestamp.
- OFF
- The timestamp is not included in those monitor messages that can contain a timestamp.
- JOBNAMES
- Message type involving the display of the name of each job when the job starts and terminates, including unit record allocation when the step starts.
- SESS
- Message type involving the display of the user identifier for each TSO terminal when the session is initiated and when it is terminated.
- STATUS
- Message type involving the display of data set names and volume serial numbers of data sets with dispositions of KEEP, CATLG, or UNCATLG whenever they are freed.
- enst
- The enablement status of the monitor message type, as specified
via the most recently issued SETCON MN command. enst is one of the following:
- ON,LOG
- Production of this message type is enabled, with messages also sent to syslog/operlog.
- ON,NOLOG
- Production of this message type is enabled, with messages not sent to syslog/operlog.
- OFF
- Production of this message type is disabled.
- connum
- The number of consoles that have requested to receive the message types displayed on this line of the output.
- tsonum
- If there are currently TSO users receiving any of the JOBNAMES,
SESS, or STATUS message types, the number of TSO users that have requested
to receive any of the message types displayed in this section of the
output. Note: Any MONITOR command request issued from a TSO user does not have a sysplex wide scope.
System action
None.
Operator response
None.
System programmer response
None.
Module
IEECB819
Source
Consoles (SC1CK)
Routing Code
-
Descriptor Code
5,8,9