CSV532I ERROR IN PARMLIB MEMBER=memname ON LINE line-number: DATA SET dsname WAS NOT ADDED TO LNKLST SET lnklstset. reason
Explanation
The LNKLST ADD statement did not complete successfully. The reason is contained within the message text.
In the message
text:
- memname
- The name of the parmlib member in which the error was found
- line-number
- The number of the line in parmlib member memname containing the error
- dsname
- The name of the data set
- lnklstset
- The name of the LNKLST set
- reason
- One of the following:
- "AFTER" DATA SET IS NOT PART OF THAT LNKLST SET
- The data set is not in the LNKLST set.
- CANNOT SPECIFY SYSTEM DATA SET
- You cannot specify the LINKLIB, MIGLIB, CSSLIB, LINKLIBE, or MIGLIBE data set either to be added or with the AFTER keyword. Those five data sets are pre-defined to be at the beginning of the LNKLST set. The LINKLIB data set defaults to SYS1.LINKLIB, but is controlled by the SYSLIB LINKLIB statement of the PROGxx parmlib member. The analogous situation is true for the MIGLIB, CSSLIB, LINKLIBE and MIGLIBE data sets. Use ATTOP if you need the data set to be immediately after the pre-defined data sets.
- IT ALREADY EXISTS
- The data set is already in the LNKLST set.
System action
The system continues processing.
Operator response
Verify that the LNKLST ADD statement specified the proper data set.
System programmer response
None.
Module
CSVPRDL
Source
Contents supervision (CSV)
Routing Code
10
Descriptor Code
5