CSV512I DATA SET dsname WAS NOT ADDED TO LNKLST SET lnklstset. reason
Explanation
The SETPROG LNKLST,ADD command did not complete successfully. The reason is contained within the message text.
In
the message text:
- dsname
- The name of the data set
- lnklstset
- The name of the LNKLST set
- reason
- One of the following:
- "AFTER" DATA SET IS NOT PART OF THAT LNKLST SET
- The data set is not in the LNKLST set.
- CANNOT SPECIFY SYSTEM DATA SET
- You cannot specify the LINKLIB, MIGLIB, CSSLIB, LINKLIBE, or MIGLIBE data set either to be added or with the AFTER keyword. Those five data sets are pre-defined to be at the beginning of the LNKLST set. The LINKLIB data set defaults to SYS1.LINKLIB, but is controlled by the SYSLIB LINKLIB statement of the PROGxx parmlib member. The analogous situation is true for the MIGLIB, CSSLIB, LINKLIBE and MIGLIBEdata sets. Use ATTOP if you need the data set to be immediately after the pre-defined data sets.
- IT ALREADY EXISTS
- The data set is already in the LNKLST set.
System action
The system continues processing.
Operator response
Verify that you specified the proper data set.
System programmer response
None.
Module
CSVPRDL
Source
Contents supervision (CSV)
Routing Code
10
Descriptor Code
5