CBR4414D Reply 'U' to use volume volser after removing write protection, or 'C' to cancel.
Explanation
OAM currently expects to write on this volume volser. However, the volume has the write protection tab set to the on position.
System action
Processing for this write request will depend on the reply to this message. If the reply is 'U', processing will continue, the operator should remove the cartridge from the drive, set the write protection tab to off, and then load the cartridge back into the drive.
If the reply is 'C', processing for this request will be re-dispatched to another volume if possible. This original volume will have the write protection status updated in the Volume Control Block and in the DB2® Volume Table. Therefore, the volume will never be selected for write requests again, until the write protection tab is set to off and the volume is mounted in a drive again.
If the reply is 'C' during label processing this request is failed, as though the operator canceled the request.
Operator response
If the reply was 'U' then remove the cartridge from the operator accessible drive, change the write protection tab to the off position, and load the volume back into the drive. If the reply was 'C' then remove the cartridge from the operator accessible drive, and the operator may possibly be prompted to mount a different volume back into the drive.
If the reply is 'C' during label processing this request is failed, as though the operator canceled the request.
Source
Object Access Method (OAM)
Routing Code
2, 4, 6
Descriptor Code
2