CBR0301I {TAPEUNITNAME | L2TAPEUNITNAME} unit-name not found.
Explanation
This message is issued for one of
the following conditions:
- OAM is processing the SETOAM commands in the CBROAMxx member of PARMLIB. The TAPEUNITNAME or L2TAPEUNITNAME keyword was specified on the SETOAM command with an esoteric unit name that the system could not find.
- An operator has entered an F OAM,UPDATE,SETOAM,scope,TAPEUNIT,unit-name or an F OAM,UPDATE,SETOAM,scope,L2TAPEUN,unit-name with an esoteric unit-name that the system could not find.
The esoteric unit name unit-name could not be located by the MVS™ unit name verification service.
System action
- If this message was issued during OAM initialization, OAM continues processing all the SETOAM commands in the CBROAMxx member of PARMLIB, but OAM initialization will terminate after all the SETOAM commands in the CBROAMxx member of PARMLIB have been processed.
- If this message was issued as a result of an operator command, the operator command stops.
System programmer response
Make sure that the unit name specified in the TAPEUNITNAME or L2TAPEUNITNAME keyword on the SETOAM command(or the TAPEUNIT or L2TAPEUN keyword on the UPDATE command) is defined to the MVS/ESA operating system. Correct the esoteric unit name specified with the TAPEUNITNAME or L2TAPEUNITNAME keyword on the SETOAM command in the CBROAMxx member of PARMLIB(or the TAPEUNIT or L2TAPEUN keyword on the UPDATE command).
Source
Object Access Method (OAM)
Routing Code
2
Descriptor Code
4