z/OS MVS System Messages, Vol 3 (ASB-BPX)
Previous topic | Next topic | Contents | Contact z/OS | Library | PDF


ATR256E

z/OS MVS System Messages, Vol 3 (ASB-BPX)
SA38-0670-00

Start of change
ATR256E
RRS PROCESSING FAILED SAVING THE process FLAG IN THE COUPLE DATA SET. RC=returncode, RSN=reasoncode

Explanation

RRS encountered an error with the IXCSETUS macro. The return and reason codes are listed in the message. The flag indicating the process, was not saved in the Couple Data Set.

In the message text:
process
Process flag, either In_Process or NotIn_Process.
returncode
is the return code from the IXCSETUS macro.
reasoncode
is the reason code from the IXCSETUS macro.

System action

RRS continues processing. In the event RRS was doing an Internal Cold Start, this has resulted in the failure of RRS processing and the termination of the RRS address space.

Operator response

Notify your system programmer.

System programmer response

Provide this information to your IBM® Support Center to correct the macro error for future uses. In the event RRS was doing an Internal Cold Start, request a cold start of RRS using the ATRCOLD procedure and then restart RRS on each system in the RRS group.

Module

ATRLMCLD

Source

Resource Recovery Services (RRS)

Routing Code

1, 2, 10

Descriptor Code

4

Parent topic: ATR messages
End of change

Go to the previous page Go to the next page

Notices | Terms of use | Support | Contact z/OS | zFavorites



Copyright IBM Corporation 1990, 2014