z/OS MVS System Messages, Vol 3 (ASB-BPX)
Previous topic | Next topic | Contents | Contact z/OS | Library | PDF


BPXI029I

z/OS MVS System Messages, Vol 3 (ASB-BPX)
SA38-0670-00

BPXI029I
AN OMVS= PARMLIB MEMBER WAS NOT FOUND OR IS IN ERROR.

Explanation

z/OS UNIX parmlib parsing has encountered one of the following problems :
  • There was a syntax error in one of the specified parmlib members
  • A specified parmlib member does not exist.
  • The operator hit Enter without specifying a parmlib member when replying to message IEA341I, which directs OMVS to come up in DEFAULT(MINIMUM) mode.
Once the system is IPLed, check the hardcopy log for additional information.

System action

The system prompts for a new OMVS= parmlib specification.

Operator response

Specify a new OMVS= parmlib specification or take the system default by specifying OMVS=DEFAULT. Hitting enter at the prompt without specifying a value also causes the system to take the default (OMVS=DEFAULT).

System programmer response

Correct the parmlib member that caused the failure. Ask the operator to reIPL the system.

Module

BPXINRIM

Source

z/OS UNIX System Services kernel (BPX)

Routing Code

1,2,10

Descriptor Code

12

Parent topic: BPX messages

Go to the previous page Go to the next page

Notices | Terms of use | Support | Contact z/OS | zFavorites



Copyright IBM Corporation 1990, 2014