Explanation
The recall or recover of the data set failed because DFSMSdss is
not at a sufficient level. The data set name and the reascode are
contained in the preceding ARC1001I or associated ARC0734I message.
The
reascode value
gives the reason the recall or recover could not be done. Valid values
for
reascode are:
- Reascode
- Meaning
- 4
- DFSMShsm determined
that it should invoke DFSMSdss to restore the data set or volume
from a full volume dump copy, or the FROMDUMP parameter was specified
for the RECOVER command. DFSMShsm then determined that DFSMSdss is
not of a sufficient release level to support invocation from DFSMShsm.
DFDSS 2.2.0 or a later release is required.
- 8
- The data set was migrated or backed up using DFSMSdss data movement but an
insufficient level of DFSMSdss is installed to recall or recover
the data set. DFDSS 2.5.0 or a later release is required.
System action
The recall or recovery of the data set ends. DFSMShsm processing
continues.
Programmer response
It may be possible to issue the recall/recover
request from a different processing unit in a multiple processing
unit environment. It may also be possible to recover a backup version
that is older than the most recent dump copy by using the GENERATION
parameter on the RECOVER or HRECOVER command. Otherwise, a sufficient
level of DFSMSdss must
be installed on the system.