ANTP0117I
FAILED TO ESTAB. ONE OR MORE PATHS TO SECONDARY

Explanation

The storage control cannot establish all the paths specified in the CESTPATH command. However, one or more paths have been established.

System action

The command is partially successful.

System programmer response

To determine the pathing status, issue a CQUERY command, with the PATHS option, to the primary device.

See the data returned with the CQUERY command to determine the action required for status other than "established".

You can also collect path information with ICKDSF (release 16 or above) with the ANALYZE command, specifying the NOSCAN and NODRIVE keywords.

Note: CQUERY PATHS will only display outbound path information. It will not display information about inbound paths. If you attempt to establish an outbound path, and it is already established inbound, the CESTPATH command will fail with ANTP0117I, but the inbound path will not appear in output of a CQUERY PATHS command directed to your local storage subsystem.

When checking path status for your local storage subsystem, issue the CQUERY PATHS command not only to the local subsystem, but also to all remote storage subsystems to which your local subsystem is connected. This will allow you to see any established paths that are inbound to your local subsystem.

Source

Peer-to-peer remote copy (PPRC).

Parent topic: ANT messages