Explanation
This message provides the output associated with
the header line produced with message ANTQ8272I. The following describes
the XQUERY output reported for the XADVANCE function:
- primary_vol – The original volume serial
number of the primary source volume.
- secondary_vol – The original volume serial
number of the secondary target volume.
- sta – The current status information
that is associated with the volume pair. The valid status states are:
- DUP – The volume pair is in duplex state, successfully recovered.
- PND – The pending volume pair is being synchronized or re-synchronized.
- SUS – The volume pair is suspended.
- con – Gives the status of the secondary
volume after the XADVANCE operation. YES means that all journal data
was successfully applied (if necessary) to the secondary volume, and
this volume is consistent to the session consistency time shown in
message ANTQ8231I. NO means that this volume is not consistent with
the consistency time shown in message ANTQ8231I.
- timestamp – The time associated with
the volume pair. The interpretation of the timestamp field is based
upon a combination of fields described below. The timestamp is always
in universal time, coordinated (UTC) format associated with the application
systems connected to the primary storage controls. The field is not
a data mover system timestamp. The timestamp field can be any
of the following:
- (blank) – If the value under STA is DUP, a blank timestamp indicates
that the volume pair has been advanced to the session timestamp reported
by message ANTQ8231I. If the value under STA is something other than
DUP, a blank timestamp indicates that the volume pair did not
complete volume initialization and no known timestamp for the volume
pair is available.
- timestamp – The timestamp reported is
given in UTC format. If the volume pair has a status of SUS, the data
on the suspended volume pair is consistent up to the time reported.
System action
XRC functions are active.
System programmer response
The information reported by this XQUERY
report is provided for the volumes requested by the XQUERY command
for the XADVANCE operation. It is point-in-time information based
on the volume status at the time the command or operation processes
the volume. See z/OS DFSMS Advanced Copy Services for
examples of XQUERY output. If the XQUERY output has been accepted
and this message has not been issued either at the system console
log or at the user ID at the MSGROUTEID parameter, see message ANTT0099I.
Source
Extended remote copy (XRC).