Explanation
text is one of the following:
The stand-alone dump program found a control block in
the specified address space in error or unavailable.
In the
message text:
- yyy
- The control block.
- asid
- The address space identifier.
- address
- The address of the control block.
- INVALID
- One of the following exists:
- The control block did not pass the validity check.
- The pointer to the control block was zero.
- The control block could not be obtained from the stand-alone dump
work file or the system paging devices because:
- An I/O error occurred on the device; in this case, message AMD033I
also appears.
- I/O failed to initiate.
- The operator replied I to message AMDO12D for a device on which
intervention was required.
- The virtual address is not defined on external storage.
- An incorrect or unavailable control block was required to page
in the control block; in this case, message AMD018I precedes this
message.
- LOOP IN
- The control block is on a chain that is too long.
Operator response
Notify the system programmer.
System programmer response
When using IPCS to format the dump,
specify the VERBEXIT SADMPMSG subcommand to see the stand-alone dump
message log. Use the diagnostic information in this message to help
determine the cause of the operating system failure.
Source
Module
Routing code
Descriptor code