Explanation
While processing a SET DAE operator command, dump
analysis and elimination (DAE) detected an error.
In the message
text:
- text
- One of the following:
- MODULE IEEMB878 COULD NOT BE LOADED
- The system could not load a required DAE service.
- THERE WAS AN UNEXPECTED ERROR. THE ABEND CODE IS cde
- The system abnormally ends DAE processing.
In the message text:
- cde
- The abend code.
- THE DAE TRANSACTION PROCESSOR IS NOT ACTIVE
- DAE is not available to modify the DAE parameters.
- THE GETMAIN FOR THE TRANSACTION FAILED
- Storage from the common service area (CSA) needed to process the
SET DAE command was not available.
- THE POST OF THE DAE TRANSACTION PROCESSOR FAILED
- The cross-memory post (XMPOST) to DAE in the DUMPSRV address space
failed.
System action
DAE does not process the SET DAE command. DAE
cannot be started or stopped.
Operator response
If requested by the system programmer, enter
the SET DAE command.
System programmer response
Where the environment makes the parameter
incorrect, either provide an ADYSETxx member that specifies the SHARE(DSN)
parameter, and start DAE; or find a system where DAE was started with
an ADYSETxx member having SHARE(DSN) specified. Then issue the GLOBALSTOP.
For
other situations, correct the error in the ADYSETxx parmlib member.
Request the operator to issue the correct SET DAE command on the appropriate
system.
Source
Dump analysis and elimination (DAE)
Module
Routing code
Descriptor code