Explanation
The target VSAM data set will be deleted and reallocated.
The reason codes (
reason_code) are as follows:
- 1
- You must use VSAM I/O to restore the data set, and the target
set is not reusable.
- 2
- The data set organization of the target did not match the source.
- 3
- The CI size of the target did not match the source.
- 4
- The IMBED attribute of the target did not match the source.
- 5
- The KEY length of the target did not match the source.
- 6
- The record length of the target did not match the source.
- 7
- The REPLICATE attribute of the target did not match the source.
- 8
- The SPANNED attribute of the target did not match the source.
- 9
- This component of an AIX® which
was previously cataloged in catalog_name was uncataloged
during a restore of its base cluster. This base cluster could not
be reallocated and, therefore, this AIX could
not be reattached. This component is no longer usable and has been
deleted from volume volume_serial_number.
- A
- The beginning RBA for the components does not match on input and
output. The input and output volumes are different volumes of a multivolume
data set.
- B
- The source data set is empty.
- C
- The pre-allocated target data set volume sequence is not in RBA
order.
- D
- The target data set had the IMBED attributes, or REPLICATE attributes,
or both. It is being deleted because the target will not have those
attributes.
- E
- The block sizes of the target and source data sets do not match.
- F
- The volume sequence number does not match.
- 10
- Primary and secondary indicators do not match on input and output.
The input and output volumes are different volumes of a multivolume
data set.
- 11
- The pre-allocated target data set is defined with a larger control
area (CA) size than the source data set.
System action
Processing continues. For reason codes 2 and 4
through 8, the source attributes override those of the pre-allocated
target.
Operator response
Programmer response
Source